Neutrik Xirium Pro Transmitter TX DANTE Line Output Module

NXP-TM-DANTE-E
produktbilde
produktbilde
Xirium

Neutrik Xirium Pro Transmitter TX DANTE Line Output Module

NXP-TM-DANTE-E
Pris på forespørsel
Neutrik Xirium Pro NXP-TM-DANTE-E XIRIUM PRO Europe Transmitter TX Digital DANTE Input Module, power cable NKXPF-F-3 must be ordered separately.   Input and output module options handle common signal type Whether the signal type is analog, digital (AES/EBU) or Dante, XIRIUM PRO offers modules to accept any of them.  Signal types may also be converted from o...

Variant:
  • Produktbeskrivelse
  • Spesifikasjoner

Neutrik Xirium Pro NXP-TM-DANTE-E

XIRIUM PRO Europe Transmitter TX Digital DANTE Input Module, power cable NKXPF-F-3 must be ordered separately.

 
Input and output module options handle common signal type

Whether the signal type is analog, digital (AES/EBU) or Dante, XIRIUM PRO offers modules to accept any of them. 
Signal types may also be converted from one type to another, simply by selecting the appropriate module. 
Need to transmit an analog signal and plug into a digital input? No problem. Select an analog input module for the transmitter, 
and the AES digital output module for the receiver. In fact, every receiver in a system can use a different output module, 
allowing for signal conversion to the type used by your device.

GENERAL SPECIFICATIONS
_
Radio frequency carrier range
IEEE 802.11a, UNII-3 band from 5725 MHz to 5825 MHz (channels 149-165), license-free
Data protocol
Proprietary (DiWA technology)
Transmit power
Conducted 8 dBm / 14 dBm (with 6 dBi antenna)
Range
Up to 500 m point to point (LOS), longer range depending on obstacles, reflexions, interferences, XROC mode
AUDIO PERFORMANCE (ANALOG TO ANALOG PER WIRELESS LINK)
_
THD + Noise (TX Gain = min.)
< 0.01 % @ 1 kHz, 4 dBu / < 0.05 % @ 20 Hz – 10 kHz, 4 dBu
Frequency response
+0.5 dB / -1.5 dB @ 20 Hz – 20 kHz ref. 1 kHz
Dynamic range
> 105 dB @ 1 kHz, A-weighted
Crosstalk
< -80 dB @ 20 kHz
Number of audio channels @ 24 mbps
2
Number of audio channels @ 6 mbps
1 (XROC mode)
Converter resolution (ADC & DAC)
24 bit
Sampling rate
48 kHz
Latency (Delay)
3.6 msec (analog to analog)
Transmission method
Compression-free, no reduction of converted data
Operating temperature
32° F to +122° F / 0 °C to +50 °C
Storage temperature
-4° F to +176° F / -20 °C to +80 °C
ADDITIONAL DIGITAL AUDIO INTERFACES
_
AES/EBU
24 bit / 48 kHz according to AES3-2003
Dante AoE (Audio over Ethernet)
proprietary protocol by Audinate®
TX SPECIFIC CHARACTERISTICS
_
Antenna 5-6 GHz – Audio Transmission
Omni-directional, 6 dBi, 25° Elevation and 360° Azimuth, N-connector male (direct mount)
Antenna 2.4 GHz – Monitor & Control
1/2 wave dipole with SMA female connectors
Number of audio channels @ 24mbps
2
Number of audio channels @ 6mbps
1 (XROC mode)
ANALOG INPUT SPECS
_
Input Mode - Line balanced
Input Level
Input Imp.
Rated Source Imp.
Max. * Connector type
10 kOhm 1000 Ohm 22 dBU XLR
* maximum input level before signal overflow,
0 dBu = 0.775 V rms
Indicators
LEDs: Power ON / Start Up / Low Battery Status / XROC mode / Linking Process / Audio transmission
Controls
Power ON / Linking Process / XROC mode
Power Supply
Mains input over powerCON TRUE1 (100-240 VAC 50/60 Hz) or internal battery (typical battery runtime 10 hours, 
depending on type of module, XROC mode, number of charging cycles and operating temperature)

Alternative produkter