Neutrik XIRIUM PRO Receiver RX Digital DANTE Output Module.
Power cable NKXPF-* and antenna NXPA-14-40-35 must be ordered separately.
Input and output module options handle common signal type
Whether the signal type is analog, digital (AES/EBU) or Dante,
XIRIUM PRO offers modules to accept any of them. Signal types may also be converted
from one type to another, simply by selecting the appropriate module. Need to transmit
an analog signal and plug into a digital input? No problem. Select an analog input
module for the transmitter, and the AES digital output module for the receiver.
In fact, every receiver in a system can use a different output module, allowing for
signal conversion to the type used by your device.
Radio frequency carrier range
IEEE 802.11a, UNII-3 band from 5725 MHz to 5825 MHz (channels 149-165), license-free
Proprietary (DiWA technology)
Conducted 8 dBm / 14 dBm (with 6 dBi antenna)
Up to 500 m point to point (LOS), longer range depending on obstacles, reflexions, interferences, XROC mode
AUDIO PERFORMANCE (ANALOG TO ANALOG PER WIRELESS LINK)
THD + Noise (TX Gain = min.)
< 0.01 % @ 1 kHz, 4 dBu / < 0.05 % @ 20 Hz – 10 kHz, 4 dBu
+0.5 dB / -1.5 dB @ 20 Hz – 20 kHz ref. 1 kHz
> 105 dB @ 1 kHz, A-weighted
< -80 dB @ 20 kHz
Number of audio channels @ 24 mbps
Number of audio channels @ 6 mbps
1 (XROC mode)
Number of receivers
Unlimited number of RX clients
Converter resolution (ADC & DAC)
3.6 msec (analog to analog)
Compression-free, no reduction of converted data
32° F to +122° F / 0 °C to +50 °C
-4° F to +176° F / -20 °C to +80 °C
ADDITIONAL DIGITAL AUDIO INTERFACES
24 bit / 48 kHz according to AES3-2003
Dante AoE (Audio over Ethernet)
proprietary protocol by Audinate®
RX SPECIFIC CHARACTERISTICS
Antenna 5-6GHz - Audio Transmission
Directional, 14dBi, 35° Elevation and 40° Azimuth, N-connector male
Antenna 2.4GHz - Control Data Transm.
1/2 wave dipole with SMA female connectors
Number of audio channels
ANALOG OUTPUT SPECS
Output Type - Line Output (balanced)
Rated Load Imp.
Nominal* Max. Level
< 800 Ohm 10 kOhm 0 dBU 22 dBU
* if TX source = 0 dBu
LEDs: Power ON / Start Up / Low Battery Status / Audio Delay / Linking Process / Audio Reception